- ${item}
Vapes Unboxing
If poor atomization occurs during the use of an e-cigarette, it can be handled according to the following steps:
First, check the status of the atomization core
Replace the atomization core: If the atomization core becomes charred, has carbon deposits or has reached the end of its service life (usually 5 to 15 days), it should be replaced in a timely manner. After installing the new atomizing core, it needs to be left to stand for 2 minutes to allow the e-liquid to fully soak, to avoid the burnt smell caused by dry burning.
Clean the atomization core: If the atomization core only has slight carbon deposits or impurities, it can be rinsed with warm water to remove surface dirt, let it dry naturally, and then reinstalled.
Second, adjust the power of the equipment
Reducing power: If the power setting of the equipment is too high, it will cause the heat generated by the heating wire to exceed the oil conduction speed, thereby triggering dry burning. It is recommended to adjust the power gradually and find the value that suits you best.
Avoid continuous use for a long time: Take a few seconds between each opening to allow the cotton time to introduce fresh oil, preventing it from burning due to the oil conduction rate not being fast enough to evaporate.
Third, check the condition of the e-liquid
Add e-liquid: Ensure that the e-liquid content in the atomization chamber is no less than 1/3, and always keep the root of the atomization core wet with e-liquid during suction to avoid dry burning.
Change the brand or flavor of e-liquid: If you suspect that the quality of the e-liquid is poor or its fluidity is not good, you can try changing to another brand or flavor of e-liquid.
Fourth, check the sealing performance of the equipment
Check the atomizer interfaces: Ensure that all interfaces of the atomizer components are tightened to prevent oil leakage or poor atomization due to loose interfaces.
Check the O-ring oil seal: If the rubber O-ring on the atomizer falls off or ages, it needs to be replaced in time to enhance the tightness between each component and prevent oil leakage.
Fifth, optimize usage habits
Avoid violent smoking: Inhaling too quickly, too deeply or too vigorously can cause incomplete combustion of the e-liquid, resulting in a burnt smell. One should inhale slowly and evenly.
Pay attention to the suction frequency: Avoid continuous and rapid suction. Give the atomization core sufficient time to conduct the oil to prevent dry burning.